Here we go..

poor quality vid but at least she runs!

Benrard done a nice job of the wiring..

Had to add some adjustment lenght to my clutch.

So it will reach.

The dash so far.

As she sits today.

The the moment of truth finally came, only just over a year since i bought it,

Some progress..

Managed to score me a sweet set of full faced chromes, look pretty sweet once they're on.

Moving her to the new home.

Finally got the tunnel all finished and welded in, 

Pulled the diff out to stop it from slipping.

New Parts:

45L Fuel Cell

All fitted in, also have a new 550hp fuel pump to move the fuel around.

RS*R tuned length extractors

Coilover sleves, yet to be fitted.

Crx Clutch master cylinder, i used the CRX one because its quite small and has a remote reservoir which will be good in the small space i have.

Also thinking of buying a kit, one similar to either or these

Tick tock..

Time for an update,

Got some new leads, half a tunnel and a EG civic radiator.

And started on the rear half of the gearbox tunnel,

The new Job came in handy, with a guillotine and finger folder things were a lot easier than I had Planned.

Now for a few welds here and there, then I'll start on the shifter surround and then the front half.

Hittin' it hard in 2011..

Been on a mad mission as the count-down has begun,

New Vs Old

Hopefully this will mean I'll be able to pull up a lot faster!

After attempting to fit up a custom alloy dash I decided that the doors had to go, and then the rest followed..

also most of the sound deadening is out, all came out pretty easily, I only used a light hammer and a putty knife, quite a bit of it came up in one piece!

I also pulled out the fuel tank, all of the interior plastics, and most of the dodgy fuel lines.

found a few new bits of rust but nothing too major!

And now the moment of truth, putting the heart in!

Im thinking an oil filter relocation kit is needed..

Sits quite nicely.

Not a lot of room, but enough!

Enough room for a turbo..

Sump is sitting a bit low for my liking, might need to make scrape plate and reinforce the sump.